Hydraulic rivet machine appear bad phenomenon how to check riveting?

To ensure the quality of hydraulic rivet machine to pay attention to every detail. Hydraulic Rivet Machine is from parts processing, and then parts assembly, and finally to the whole machine delivery such a process. If there is a mistake in any link, the final problem will be reflected in the use of the whole machine. So after the use of the customer to find the cause of the problem to solve the problem, it will be very troublesome. The Devil is in the details. Details in place so that the riveting machine failure probability will be very small. Thus also can better guarantee the customer's benefit. Poor riveting phenomenon is generally referred to, riveting after the effect does not meet the use of parts and components standards, or can not achieve the customer expected effect riveting products can not be used.

(1) to check whether the length of the riveting head of the riveting equipment conforms to the provisions, the standard length of the riveting head is listed below. In the use process may carry on the revision according to the actual situation. (2) if the riveting pressure is too large or too small, the height of the rivets after riveting will not reach the standard. So it is very important to adjust the riveting pressure. The method of adjusting the riveting pressure can refer to the article“How much the pressure of the hydraulic riveting machine is, how to adjust the riveting pressure”, in addition, it especially emphasizes the magnitude of the riveting pressure, which directly affects the riveting quality and efficiency of the riveting equipment, in the actual use, the size of the adjustment pressure is not in place once, generally according to the actual situation many times to adjust to the best. (3) check whether the rivet allowance is too long or too short the rivet allowance is too long the height of the rivet out is too high, the Rivet Allowance is too short the height of the rivet after the rivet is too low. Will cause the riveted parts can not meet the standard. So it's important to have a proper rivet margin. (4) check whether the table is locked there are three screws for locking the table. Riveting process after adjusting the height must be locked table. If the table is not locked during riveting. There will be shaking will also cause the riveted parts after the failure. Riveting equipment in the factory before, riveting machine manufacturers will be in accordance with conventional standards for packaging and delivery. After arriving at the customer's factory, it is necessary to fine-tune the actual riveted parts until the requirements are met. At the same time the riveting machine also needs regular maintenance clean. This can effectively extend the life of the riveting machine.