The advantages of tianlu hydraulic rivet machine [ press down positioning accuracy ] can be used adjustable cylinder mechanical positioning -LRB-accuracy 0.05 mm) , positioning gauge electric position-LRB-ng (accuracy 0.03 mm) , pressure sensor pressure positioning (accuracy 0.1 kgf) .
Hydraulic and electrical components made in Japan, France, low failure rate, low noise, easy maintenance. High Factor of safety. Full safety design. The flat button can be activated with both hands, and the machine can be started by simultaneously clicking the button within 0.5 seconds. There is an emergency stop switch in the middle of the Start button. Emergency can be handled in time. The front of the worktable is provided with a safety fence. When the machine is running, if the hand accidentally reaches into the workspace, the machine will automatically rise, grating failure will light up the red light, high Factor of safety.
The machine is equipped with up and down button, convenient mold installation and calibration. System regulation is simple: pressure by the relief valve regulation, speed by the speed control valve regulation, travel by proximity sensors and down time regulation. Reduce holding time, record and calculate yield.
[ energy saving ] since the hydraulic cylinder uses a fast combination cylinder, the motor only needs 2.2 kw power: the motor automatically stops after running for 10 minutes to avoid additional power consumption caused by not running the machine, only need to restart the motor when working. The main cylinder and driven cylinder are used in the hydraulic press, which can realize the rapid rise and stable supercharging of the hydraulic press and improve the production efficiency.
[ low noise ] noise level shall not exceed 60 decibels when the equipment is on standby. The working table is provided with a blanking trough and a blowing device. Easy to move the table under the table to install Casters and cup, can be moved gently, labor-saving.