Production process of riveting press

Production process of riveting press

First levelling processing, to ensure the flatness of the fuselage, the whole machine welding, to ensure high accuracy. The machine cuts the fuselage to keep the pressure in balance. The fourth part is the tempering process to ensure the hardness and strength of the machine. The fifth step is floor boring machine, to ensure the accuracy of processing. Finally, mass production, precision customization.

Preparation before use

This machine uses 380/three electricity, first of all, the three electricity into the box leakage protector inlet. Then Open the machine left guard plate, open the fuel tank cap, add 46 # anti-wear hydraulic oil. The third step is to open the electric box, close the electric box door handle pressure adjustment handle box anticlockwise direction (-) three turns, press the start key to observe the positive rotation of the motor, reverse does not work, if reverse off the main gate adjustment line sequence.

Specific operation

The automatic/manual switch of the Operation Panel is set to manual, then the workpiece that needs to be pressed and riveted is put into the lower part of the mould, press the foot of the down switch foot, and do not leave the switch, the machine will continue to work downwards and then adjust the pressure handle to observe the gap between the upper die and the workpiece until it is completely in place. Put the panel auto/manual to auto, the upper die will be raised automatically. Observe the actual effect of the workpiece, if you need to fine-tune the pressure can be directly adjusted, and then can be directly mass production.